The Toodle comes with the rear cover assembled Normally there is no need to open the rear cover In case the rear bearing is stuck inside the Toodle housing during Tool Assembly removal it is essential to disassemble the rear cover in order to ID: 600118
Download Presentation The PPT/PDF document "Rear Cover Assembly" is the property of its rightful owner. Permission is granted to download and print the materials on this web site for personal, non-commercial use only, and to display it on your personal computer provided you do not modify the materials and that you retain all copyright notices contained in the materials. By downloading content from our website, you accept the terms of this agreement.
Slide1
Rear Cover Assembly Slide2
The
Toodle comes with the rear cover assembled.Normally, there is no need to open the rear cover.
In case the rear bearing is stuck inside the Toodle housing during Tool Assembly removal, it is essential to disassemble the rear cover in order to properly remove it.Also, after long storage of the Toodle, it is recommended to remove the rear cover, inspect the O-Ring and clean all Toodle parts before further use.Slide3
R
emove the tool holder from the machine, and place the tool holder with Toodle
in the tool holder clamping device.Slide4
Remove the Toodle from the tool holder.
1. Release screw - CCWSlide5
Unscrew the rear cover CCW using a suitable tool (as snap rings pliers), and remove from housing.Slide6
Lightly knock the rear bearing out of the housing using a screw driver if needed.Slide7
E
xamine
the rear cover O-Ring seal. Change the O-Ring as necessary.Slide8
Thoroughly clean all Toodle parts and remove any corrosion marks. Slide9
Place the rear cover back into the Toodle housing
.Slide10
Screw
the rear cover CW using a suitable tool (as snap rings pliers
).
Torque = 5
to 10 [Nm]
Holes diameter = 2 [mm]
CWSlide11
Note
the rear cover position as compared to the
housing.Slide12
Place the Toodle into the tool holder.Slide13
Tighten tool holder after placing Toodle in place.
Note: the Toodle front cover surface should touch the tool holder surface.
Tighten screw - CCW