Blade alignment to the miter slot Instructions 1 Disconnect the saw from the power source Check distance from a miter slot to the side of a tip of the blade on the front side of the blade with a square ID: 174544
Download Presentation The PPT/PDF document "Delta Contractors Saw 36-725" is the property of its rightful owner. Permission is granted to download and print the materials on this web site for personal, non-commercial use only, and to display it on your personal computer provided you do not modify the materials and that you retain all copyright notices contained in the materials. By downloading content from our website, you accept the terms of this agreement.
Slide1
Delta Contractors Saw 36-725Blade alignment to the miter slotInstructions
1. Disconnect the saw from the power source.Slide2
Check distance from a miter slot to
the side of a tip of the blade on the
front side of the blade, with a square
as shown.Rotate the blade so the same blade tip is at the rear side and recheck distance at the rear side of the blade.
If the distances from the miter slot
to the blade differs by more than .010 “, front to rear side of the blade,
proceed to the next step. Slide3
Remove rear panel by
Removing four screws
4.Slide4
5. Loosen wing nut on dust chuteSlide5
6. Swing Dust chute down
Out of the way.
7. Loosen 2 screws.Slide6
Loosen the two set screws only slightly
with either the “T” handle or “L” shaped
3/16” hex wrench supplied with the saw.Slide7
Push or pull on the end
i
f the motor gently until the distance from the miter slot to the blade is equal on the front and back side of the blade. Remember to rotate the blade so the distance
is measured on the same tooth of the blade.Slide8
9. Retighten the two set screws.Slide9
Reposition the dust chute
and retighten the wing nut.Slide10
Reposition the
rear panel and
fasten with four Screws.