Presentations text content in TRENCHLESS TECHNOLOGY
Slide1
TRENCHLESS TECHNOLOGY
Rohit
Chaurasia
71
/08
Slide2WHAT IS TRENCHLESS TECHNOLOGY?
Trenchless technology is basically making tunnel below the surface and installing service lines like gas pipes or telecommunication cables without disruption to flow and minimum damage to the environment.
Slide3TRENCHLESS TECHNOLOGY METHODS
New InstallationRehabillation and Renovation
Slide4New Installation
MicrotunellingHorizontal directional DrillingShort Drive SystemGuided Drilling
Slide5Microtunnelling
Remote controlled mechanical tunnel systems where the soil is removed from cutting head with the new pipe line which is advanced by pipe jacking
Slide6Horizontal Directional Drilling
Genraly used for installing pressure pipes under major obstacles like large rivers, airports etc.Tunnels of approximately 1.5 km long and of up to 1200mm diameter can be made with the help of horizontal directional drilling.
Slide7Short Drive Systems
Auger BoringImpact MolingRod pushingPipe Ramming
Slide8Auger boring
Auger Boring also known as “bore and jack”It involves simultaneous jacking a steel case forward while removing soil via rotating auger flight.
Slide9Impact Moling
Moling is a method, which forms the borehole by compressing the Earth that immediately surrounds the compacting device.
Slide10Rod pushing
Rod pushing is the technique in which bore of 50mm diameter is formed by displacement . It is used for the installation of pipes of 15mm diameter over 30-40 mm lengths.
Slide11Pipe Ramming
Pipe Ramming, the pipe is rammed through the soil by using a device attach to the end of the pipe. This method is not suitable where there are solid rock formations. Usually up to 2000 mm diameter pipes can be laid by this technique.
Slide12Guided Drilling
Guided drilling employs the excavation or soil displacement with compact light weight rig for rapid mobilisation.
Slide13Rehabilitation & Rennovation
Pipe BurstingPipe EatingRelining the existing pipesLocalised repairSliplining
Slide14Pipe Bursting
An existing pipeline can be replaced with pipeline of the same or larger dimension without opening the ground.
Slide15Pipe Eating
Pipe eating is online microtunnel replacement technique.The existing pipeline is crushed and removed through a new pipeline.
Slide16Relining the Existing Pipes
This method require access, usually by manholes, at both end of the pipes.Pipe is relined at the places where the joints have moved or sections are missing ,but the passage should be available.
Slide17Localized Repairs
Local defects may be found in pipes are due to cracking or joint failures.Chemical grouting with urethane and similar materials are used in sewer rehabilitation.
Slide18Sliplining
A new pipeline of smaller diameter is inserted into the defective pipe.The inserted pipe is then expanded to fit tightly against the existing wall.
Slide19Pre-requisites
Site investigationCondition surveyUnderground detection
Slide20Advantages of “No-Dig” Technology
Reduces damages of valuable surface.
Save resources.
Accident free.
Avoids traffic jam
Reduces impact on environment.
Saves underground space.
Slide21Conclusions
With all round developments in various fields like petrochemicals where conveyance of gas, crude and refined products over long distances is common, telecommunication and water supply and sewerage etc. It is becoming increasingly necessary that these lines are laid underground leaving space above surface comparatively free. i.e., Adoption of trench less technology is the only remedy.
Slide22Thank you
THANK
YOU
TRENCHLESS TECHNOLOGY
Download Presentation - The PPT/PDF document "TRENCHLESS TECHNOLOGY" is the property of its rightful owner. Permission is granted to download and print the materials on this web site for personal, non-commercial use only, and to display it on your personal computer provided you do not modify the materials and that you retain all copyright notices contained in the materials. By downloading content from our website, you accept the terms of this agreement.