42T blades should be on both the right and left sides of the 6T chipper blades The points of th e 42 Teeth should always be orientated on the outside of the set up When Stacking the set of blades make sure the 6T chipper blades are aligned in the gu ID: 73504
Download Pdf The PPT/PDF document "MLCS Super Stack Dado Blade Set Mountin..." is the property of its rightful owner. Permission is granted to download and print the materials on this web site for personal, non-commercial use only, and to display it on your personal computer provided you do not modify the materials and that you retain all copyright notices contained in the materials. By downloading content from our website, you accept the terms of this agreement.
MLCS #9106 Super Stack Dado Blade Set Mounting Instructions Set up the Super Stack Dado Blade Set with the 42T Blades on the outside of the chipper blades. 42T blades should be on both the right and left sides of the 6T chipper blades. The points of th e 42 Teeth should always be orientated on the outside of the set up. When Stacking the set of blades make sure the 6T chipper blades are aligned in the gullets of the 42T blades and the carbide does not make contact with the steel body and shoulder of th e 42T blades. S t a c k D a d o B l a d e S e t Item # 9106 Warning: Always use proper safety protection and follow OSHA regulations. Wear a dusk mask, goggles, and keep hands away from the saw blade. Use at your own risk. Note: For deep dados or when cutting dados with a low power table saw, cut 1/2 of the dado depth, then raise the blade to full depth and finish cut. Copyright 200 9 MLCS ltd. Page 71 Width of Dado Outside Blades 1/16 Chipper 3/32 Chipper 1/8 Chipper 1/4 2 - - - 5/16 2 1 - - 11/32 2 - 1 - 3/8 2 - - 1 13/32 2 1 1 - 7/16 2 1 - 1 15/32 2 - 1 1 1/2 2 - - 2 17/32 2 1 1 1 9/16 2 1 - 2 19/32 2 - 1 2 5/8 2 - - 3 21/32 2 1 1 2 11/16 2 1 - 3 23/32 2 - 1 3 3/4 2 - - 4 25/32 2 1 1 3 13/16 2 1 - 4 27/32 2 - 1 4 29/32 2 1 1 4 MLCS #9106 Super Stack Dado Blade Combination Chart S t a c k D a d o B l a d e S e t Item # 9106 Shims are supplied to allow for fine adjustments to the width of the dado. Copyright 200 9 MLCS ltd. Page 7 2