/
Application Tips HEETROCK Brand Acoustical Sealant Pre Application Tips HEETROCK Brand Acoustical Sealant Pre

Application Tips HEETROCK Brand Acoustical Sealant Pre - PDF document

luanne-stotts
luanne-stotts . @luanne-stotts
Follow
428 views
Uploaded On 2015-04-22

Application Tips HEETROCK Brand Acoustical Sealant Pre - PPT Presentation

Provide adequate ventilation to carry off excess moisture Surfaces to be caulked must be clean dry and free of dust Application Use a caulkingtype gun Apply 14 minimum round bead of sealant 58 maximum to seal perimeter of soundrated partition Seal s ID: 53708

Provide adequate ventilation

Share:

Link:

Embed:

Download Presentation from below link

Download Pdf The PPT/PDF document "Application Tips HEETROCK Brand Acoustic..." is the property of its rightful owner. Permission is granted to download and print the materials on this web site for personal, non-commercial use only, and to display it on your personal computer provided you do not modify the materials and that you retain all copyright notices contained in the materials. By downloading content from our website, you accept the terms of this agreement.


Presentation Transcript

Application Tips HEETROCK Acoustical Sealant Installation of SHEETROCK Brand Acoustical Sealant should not begin until building is enclosed and building temperatures are maintained at 55° F (13° C) minimum. Provide adequate ventilation to carry off excess moisture. Surfaces to be caulked must be clean, dry, and free of dust.Use a caulking-type gun. Apply 1/4" minimum round bead of sealant (5/8" maximum) to seal perimeter of sound-rated partition. Seal sound-rated partitions on both sides where facings abut dissimilar materials: around perimeter; in the angle formed by panels and abutting dissimilar materials; at all intersections; at all panel terminations in door and window frames; and at control joint locations before attaching the control joint to the panels. Apply continuous beads of sealant around all openings formed for outlets, lights, etc. Completely butter the outside of electrical boxes. Cut gypsum panels with 1/8" maximum relief at perimeter to receive sealant. Install before sealant skins. Trademarks The following trademarks used herein are owned by UnitedStates Gypsum Company or a related company: S HEETROCK Note Products described here may not be available in all geographic markets. Consult your U.S. Gypsum Company sales office or representative for information.Manufactured byUnited States Gypsum Company 550 West Adams StreetChicago, IL 60661800 USG.4YOU (874.4968) J1759/rev. 6-13© 2013 United States Gypsum Company Notice We shall not be liable for damages, directly or indirectly sustained, nor for any loss caused by application of these goods not instructions or for other than the intended use. Our liability is expressly limited to replacement of defective goods. Any claim shall writing to us within thirty (30) days from date it was or reasonably should have been discovered. Safety First! Follow good safety practices. Read material safety data sheets and related literature on products before specification and/or installation. Do Don’t DO SHEETROCK Acoustical SealantSHEETROCK Acoustical Sealantsound pathsteel wall panels DON'T electricaloutlets