/
Alix McAra 16 I started of my key fob by picking the plastic that I wanted to use and covered it with masking tape so that I could draw on the design that I had chosen and mark on the sizes then I started to saw it out using a coping saw ID: 540933 Download Presentation
Download Presentation - The PPT/PDF document "My Key Fob" is the property of its rightful owner. Permission is granted to download and print the materials on this web site for personal, non-commercial use only, and to display it on your personal computer provided you do not modify the materials and that you retain all copyright notices contained in the materials. By downloading content from our website, you accept the terms of this agreement.
Presentation on theme: "My Key Fob"— Presentation transcript
Slide1
My Key Fob
Alix McAra
1.6Slide2
I started of my key fob by picking the plastic that I wanted to use and covered it with masking tape so that I could draw on the design that I had chosen and mark on the sizes, then I started to saw it out using a coping saw. Slide3
I then draw filed all the edges.Slide4
After that I used wet and dry paper to give it a smoother surface. Slide5
After the wet and dry paper
I then rubbed brasso around the edges until it was shiny and even smoother.Slide6
When the edges were smooth and shiny after the brasso I used a white cloth to rub the plastic to polish and dry it.Slide7
When I had finished polishing it I marked where I wanted the circle in the middle of my A to go and then drilled it slowly so that I didn't crack the plastic around where the hole was going to be drilled. After that I then marked where I wanted my key hole to go and then again I slowly drilled .Slide8
Lastly I chose the size of the key ring and put it through the hole I had just drilled.Slide9
My finished Key FobSlide10
Thank You