Gluing tips for NX10 also applicable for XE70 XE100 Andrey Malkovskiy Stanford 090317 Make sure the rear end of the tip is located next to the small round indents in the steel tip base and is not tilted ID: 779748
Download The PPT/PDF document "superglue Place a small amount of superg..." is the property of its rightful owner. Permission is granted to download and print the materials on this web site for personal, non-commercial use only, and to display it on your personal computer provided you do not modify the materials and that you retain all copyright notices contained in the materials. By downloading content from our website, you accept the terms of this agreement.
Slide1
superglue
Place a small amount of superglue (Loctite) onto the steep tip holder
Gluing tips for NX-10 (also applicable for XE70, XE100)
Andrey Malkovskiy, Stanford, 09/03/17
Slide2Make sure the rear end of the tip is located next to the small round indents in the steel tip base and is not tilted
Andrey Malkovskiy, Stanford, 09/03/17
Slide3Too much glue on one side, the tip is tilted now
Use a second set of tweezers to press the tip down while the 1
st
set is holding it in place, this way the glue will be more evenly distributed under the tip
Andrey Malkovskiy, Stanford, 09/03/17
Slide4Generally, this is how it should look like:
Andrey Malkovskiy, Stanford, 09/03/17
Slide5Unfortunately, the NX-10 PSD is very sensitive to tip position and it seems the best position to glue chips with multiple tips is to have the tip of interest (with a sphere, for example) in the middle of the steel plate
Andrey Malkovskiy, Stanford, 09/03/17