/
Workshop Rotating Platform Workshop Rotating Platform

Workshop Rotating Platform - PowerPoint Presentation

trish-goza
trish-goza . @trish-goza
Follow
370 views
Uploaded On 2017-04-14

Workshop Rotating Platform - PPT Presentation

Stepbystep assembly instructions c 2015 National Fluid Power Association Contents of Rotating Platform Kit Wooden pieces ⅜ crosssection 4 X 8 2 pieces with 45 ends Green corner gussets 1 card ID: 537238

2015 fluid power association fluid 2015 association power national pieces glue platform wheel dowel hole shown syringe plunger frame

Share:

Link:

Embed:

Download Presentation from below link

Download Presentation The PPT/PDF document "Workshop Rotating Platform" is the property of its rightful owner. Permission is granted to download and print the materials on this web site for personal, non-commercial use only, and to display it on your personal computer provided you do not modify the materials and that you retain all copyright notices contained in the materials. By downloading content from our website, you accept the terms of this agreement.


Presentation Transcript

Slide1

Workshop Rotating Platform

Step-by-step assembly instructions

(c) 2015 National Fluid Power AssociationSlide2

Contents of Rotating Platform Kit

Wooden pieces (⅜” cross-section): 4 X 8”; 2 pieces with 45° ends

Green corner gussets: 1 card

Syringes, 20cc: 2 (1 has a hole in the plunger)

Plastic Tubing: 1 length approx. 12”

Syringe Holder: 1Wooden dowel, 3/16” diam.: 1 X 1¾”; 1 X ⅞”Wooden dowel, ⅞” diam. X 1Large wheel, with ⅞” hole X 1, Medium wheel X 14” Square Platform with ⅞” & 3/16” holesPlus a small piece of sandpaper

(c) 2015 National Fluid Power AssociationSlide3

Carefully cut the four 8” pieces into eight 3

⅝” pieces Make two 4”squares using the eight 3⅝” pieces. To join the pieces of wood together use green triangles on one side only and a small amount of wood glue on each triangle. Also glue the two other pieces into one of the frames as shown

(c) 2015 National Fluid Power AssociationSlide4

Glue the ⅞” dowel into the center hole of the platform and the longer 1

¾” dowel into the corner hole of the platform. Glue the other the,

⅞” long dowel into the wheel

(c) 2015 National Fluid Power AssociationSlide5

When the frames are dry glue them together. Apply glue to the sides without the green corners. The frame with the extra pieces goes on the top

(c) 2015 National Fluid Power AssociationSlide6

Cut the green card on the top frame in the 90° corner of the large triangle

(c) 2015 National Fluid Power Association

 This oneSlide7

Glue the large wheel onto the frame as shown. Make sure the

⅞” dowel that is attached to the platform rotates freely in the hole of the large wheel. Cut card to cover the wheel and glue the shape to it as shown

(c) 2015 National Fluid Power AssociationSlide8

Attach the plunger (with hole in it) of one of the syringes to the platform and the syringe clip to the wheel as shown

(c) 2015 National Fluid Power AssociationSlide9

Assemble the model as shown and then push the tubing onto the syringe. To operate the platform attach the other syringe, with its plunger out, onto the tubing and then press its plunger in.

(c) 2015 National Fluid Power Association