For all information regarding how to make tempeh or purchasing of materials for tempehtofu making please visit wwwmrtempehcomau Completed simple incubator This is a simple set of step by step instructions so that anyone can make a simple cheap incubator for the home use of making de ID: 315635
Download Presentation The PPT/PDF document "How to make a simple tempeh incubator." is the property of its rightful owner. Permission is granted to download and print the materials on this web site for personal, non-commercial use only, and to display it on your personal computer provided you do not modify the materials and that you retain all copyright notices contained in the materials. By downloading content from our website, you accept the terms of this agreement.
Slide1
How to make a simple tempeh incubator.
For all information regarding , how to make tempeh or purchasing of materials for tempeh/tofu making please visit
www.mrtempeh.com.auSlide2
Completed simple incubator.Slide3
This is a simple set of step by step instructions so that anyone can make a simple, cheap incubator for the home use of making delicious fresh white tempeh!Slide4
You will need:
1 Styrofoam box,1 basket that fits inside the box,2 plastic rods and a 25 watt aquarium heater.Slide5
For tools you will need: 1 measure tape,1 marker,1 knife or hole saw and a drill bit bigger than the diameter of the plastic rods.Slide6
1: mark the expected water level, this needs to cover your aquarium heater generously . 2: Mark the bottom of the hole that you will cut. Leave about 25 mm space between the water level and the bottom of the hole.
3 : cut the hole, about 50 mm diameter so the heater will fit through.Slide7
Once you have cut the hole, round or square, place your basket on the 2 plastic rods and mark where to make the
holes , about
40 mm below the
top , use
your drill bit manually, no need for a drill.Slide8
Once you have drilled the four holes, push the plastic rods in position and place the basket on top. It should be suspended above expected water level and not touching the lid, once it is in position.Slide9
Set the temperature of your heater to 30 Degrees
Celcius
, feed through the hole and place on the bottom, making sure it is fully submerged under water.Slide10
It should look this this, make sure the water level covering the heater and turn it on.Slide11
Place the lid on top and check the ambient temperature after 24 hours, it should be around 30 Degrees.Slide12
Once the temperature has stabilized around 30 degrees, proceed to prepare your beans ,inoculate , put in the bag and place in the basket.Slide13
Place the lid on top, close the box and proceed the fermentation as per instructions that came with your order of the tempeh kit.Slide14
Alternatively you can place a rack on top of some rods and place your bags on there to ferment.Slide15
Full instructions for successful tempeh making will come with your order of a tempeh kit or tempeh starter ,
see you at:
www.mrtempeh.com.au
thanks and good luck