18316 18148 hole punch top depth gauge base depth gauge 316148 hole punch 18316 fig 2 18316 SURE THAT THE TOOL AND THAT THE OF THE TOOL FAILURE AND VOID WARRANTY COMBINATION CHAR ID: 828825
Download Pdf The PPT/PDF document "Finally - no clicking, banging, pounding..." is the property of its rightful owner. Permission is granted to download and print the materials on this web site for personal, non-commercial use only, and to display it on your personal computer provided you do not modify the materials and that you retain all copyright notices contained in the materials. By downloading content from our website, you accept the terms of this agreement.
1 Finally - no clicking, banging, pounding
Finally - no clicking, banging, pounding, twisting, grunting or cussing! This all-in-one tool punches and sets eyelets, snaps, and so much more. Easily punch through almost any material, even thick bookboard, then set eyelets, snaps or any embellishment in your project. It is perfect for all kinds of projects, even custom bindings. Let your imagination run wild with this amazing tool! . Determine the desired hole size. Set hole depth using the depth gauge near the punch. Make sure that TOP and BASE black cubes are locked and secured before moving on. Insert material in the appropriate slot, and punch by compressing the handles 2. Select your snap, eyelet or metal embellishment. Determine the correct TOP and BASE combination (see combination chart below) for the type of metal embellishment selected and rotate them to the correct position. Make sure that TOP and BASE black cubes are locked in position and secured before in the tube of the snap or eyelet and compress Note: The back side of your snap or eyelet may be bent, curled, or look smashed which is totally normal. Non-uniform crimping may occur depending upon the type of metal embellishment used and how well you line up the tool when crimping. Warning: Failure to follow instructions for usage may result in damage of this tool and will void For all 3/16 inch standard and round standard snaps For all 1/8 inch standard and FLAT SETTER and square shaped metal For all 3/16 inch standard, oversized, and For other non-standard, oversized, and For all 1/8 inch standard,For snaps and eyelets where the eyelet tube is not 1/83/16 1/8” hole punch top depth gauge base depth gauge 3/16” hole punch 1/83/16 fig. 2 1/83/16 SURE THAT THE TOOL AND THAT THE OF THE TOOL. FAILURE AND VOID WARRANTY. COMBINATION CHART BASE TOP B2 BASE TOP B2 1 2 *This shows the correct way to set an Extra Large Eyelet.See Top and Base Combination Charts for correct 4 B C A hole puncher, eyelet &