If a material does not function properly then it means that it had failed or went through failure The usual causes of failure are 1 Improper materials selection 2 The misuse of the material ID: 805341
Download The PPT/PDF document "CHAPTER 7 : FAILURE Failure" is the property of its rightful owner. Permission is granted to download and print the materials on this web site for personal, non-commercial use only, and to display it on your personal computer provided you do not modify the materials and that you retain all copyright notices contained in the materials. By downloading content from our website, you accept the terms of this agreement.
Slide1
CHAPTER 7: FAILUREFailure: If a material does not function properly, then it means that it had failed or went through failure. The usual causes of failure are: 1. Improper materials selection 2. The misuse of the material 3. Improper fabrication of the materialFracture: It is the separation of a material into two or more pieces when a stress is applied to the material. There are two types of fracture: Ductile Fracture and Brittle Fracture.
Slide2CHAPTER 7: FAILUREA. Ductile Fracture: Ductile materials usually have a plastic deformation before fracture. Ductile fracture is a very slow process. It does not happen immediately. The crack of a ductile fracture is stable. In ductile fracture, the material absorbs a lot of energy before the fracture. Figure 8.1 Types of ductile fracture surfaces
Slide3CHAPTER 7: FAILUREFigure 8.1
(a) for extremely soft metals, such as pure gold and lead (kurşun), and polymers and inorganic glasses at high temperatures. These highly ductile materials neck down to a point fracture with 100% area reduction. Figure 8.1 (b) This is the most common type of fracture for ductile materials.
Slide4FAILURE Train wreck at Montparnasse 1895
Slide5Ductile Fracture of a specimen strained axially
Slide6Schematic representation of the steps in ductile fracture.
This fracture has a small neck (boyun). This fracture process occurs in several stages: first the neck forms, then microvoids form, these microvoids enlarge and form a crack which is perpendicular to the applied stress.
Slide7B. Brittle Fracture: Brittle materials usually have a very little or no plastic deformation before fracture. Brittle fracture is a very rapid process. The crack propogates immediately. The crack of a brittle fracture is unstable. In brittle fracture, the material absorbs very little energy before the fracture. The crack propogates perpendicular (dikine) to the direction of the applied stress. The brittle fracture surface is very flat. Figure 8.1 (c) The figure of the brittle fracture.
Slide8Ductile to Brittle Transition: Some materials may show ductile to brittle transiton. Ductile to Brittle transition occurs usually with decreasing temperature. When temperature of the materials is decreased, the impact energy drops down from a high value (Ductile behavior) to a low value (Brittle behavior).
Slide9Fracture of an Aluminum Crank Arm. Bright: Brittle fracture. Dark: Fatigue fracture.
Slide10FATIGUEIt is a form of failure that occurs in structures such as in bridges, aircraft, etc. Fatigue is usually caused by dynamic and fluctuating (inip çıkan) stresses. Fatigue can be found in polymers, metals and ceramics. Fatigue occurs after a very long period of repeated stresses on the material.