Getting Going Connect Controller Connect power to the controller 12V 1A Connect the controller to the network Use a network switch or crossover cable Ethernet Switch AAN100 APACS PC Check Operation ID: 909159
Download Presentation The PPT/PDF document "System Startup Configuring APACS & A..." is the property of its rightful owner. Permission is granted to download and print the materials on this web site for personal, non-commercial use only, and to display it on your personal computer provided you do not modify the materials and that you retain all copyright notices contained in the materials. By downloading content from our website, you accept the terms of this agreement.
Slide1
System Startup
Configuring APACS & AAN Controllers
Slide2Getting Going…
Slide3Connect Controller
Connect power to the controller
12V ~1A
Connect the controller to the network
Use a network switch or crossover cable
Ethernet
Switch
AAN-100
APACS PC
Slide4Check Operation
When everything is connected correctly, check the LEDs to confirm proper operation
Slide5Program the IP Address
InitAAN utility
to program
Ping
to confirm
Slide6Connect Reader Interface
Connect the AIM-4SL reader interface to the first communication port
Use ‘crossover’ wiring (T>R, R>T)Set address of AIM-4SL with DIP switch
Slide7Connect Reader
Follow reader
instructions to connect wiresfor power, commsand LEDs/buzzer
Slide8Install Software
Install from CD or download package from Apollo Website
A key is required to use APACSHardware key – USB dongle that plugs into the PCSoftware key – A file that is downloaded from Apollo’s website after providing an activation code. Save the file in the APACS install directory.
Slide9System Configuration
Launch System Configuration
Default user/password: 1/1Add PCRight-click system tree:
AddNumber isn’t needed
IP Address of local PC, usenumeric address or name
Slide10System Configuration
Add the controller to the PC
Network communication typeSet IP Address in Communication Settings
Slide11Add Reader
Add the reader to the controller
The first reader on an AIM-4SL is always master (matches number on DIP switch)Select proper Port
and AddressIf you don’t have a door contact connected yet, go to
hardware menu and unselect door contact control
Slide12Config Check
Your system tree should now look like this:
Slide13Permissions
Assign permissions to the default permissions
set: ‘1’Make sure Message and Control
permissions are granted for all objects
Slide14Check Global Settings
Make sure global settings are correct for the system
Click on root of system tree
Save configuration
Slide15Start Communication
Launch Alarm Mode
If messages are displayed for ‘Online’ then configuration is correct. Also check with Hardware Status
Slide16Test a Card
Swipe a card at the reader
A message should display with the resultCard Format Error or Wrong Facility Code
Slide17Set Card Format
Change Card Format in Controller Configuration to match the cards in use
Set the bit length and facility code
Save configuration and swipe the card again
Slide18Create Access Level
Name the Access Level and then add reader/time zone
Use the system time zone ‘Always’
Slide19Create User & Assign Access Level
Use the card number to create a new user with card and assign the AL
Slide20First Access Grant