Installation Instructions 2 3 4 5 7 6 1 Determine switch mounting location based on wall or construction applicable standards and intended use Punch out holes in the jamb box in the areas provided ID: 512720
Download Pdf The PPT/PDF document "Jamb Switch Box" is the property of its rightful owner. Permission is granted to download and print the materials on this web site for personal, non-commercial use only, and to display it on your personal computer provided you do not modify the materials and that you retain all copyright notices contained in the materials. By downloading content from our website, you accept the terms of this agreement.
Jamb Switch Box Installation Instructions 2 3 4 5 7 6 1 Determine switch mounting location based on wall or construction, applicable standards and intended use. Punch out holes in the jamb box in the areas provided. Use caution and do not damage any electronics present in the box. Drill holes in mounting surface using the mounting box as the template. In hardwired installations, drill a wiring access hole. Insert the appropriate fastener through the box and into the mounting surface and tighten securely. Make sure the box is mounted at, not twisted. In hardwired installations, wire the jamb switch to the door controller using spade terminals to connect to the N.O. and COMMON contacts. A knockout area is provided for routing switch wires into the box. For radio-controlled installations, wire the jamb switch to the transmitter using the N.O. and COMMON contacts. Use the enclosed wrench to tighten the #6-32 screws into the jamb box (as shown in the top drawing on right). Test for proper operation. Directions Jamb Box Assembly Hollow Wall Mounting Observe all manufacturers’ recommendations for safety and operation of their products. ANSI/BHMA standards that o er speci c recommendations for each type and class of automatic door have been developed. To obtain a copy of the ANSI/ BHMA standard that applies to the installation, visit www.buildershardware.com or www.ansi.org . DELUXE JAMB SWITCH JAMB SWITCHMOUNTING BO www.hotron.com JAMB SWITCH BOXJAMB SWIT CH MOUNTING SCREWMOUNTING SURFACE Hotron Ltd.26 Dublin Street, Carlow, Ireland. TEL: +353 (0)59 914 0345 FAX: +353 (0)59 914 0543Email: info@hotron.comwww.hotron.com 223-0132-000H Rev. E 5/15 1-1/4 3-3/8 3-3/4DRILL 7/64" AND TAP (2 PLACES FOR #6-32 MACH. SCREWFOLD ON DOTTED LINEFOR 1-3/4" JAMB TEMPLATE1-1/4" X 3-3/8"CUTOUT TIGHTEN SCREWS THROUGH HOLESIN COVER PLATE WITHHEX KEY PROVIDED18 GA WIREMAX. Jamb Switch Installation Instructions